This version (06 Sep 2016 13:38) was approved by Venkatesan Krishnamoorthy.The Previously approved version (06 Sep 2016 13:37) is available.Diff

Sawtooth With Phase and Gain

Click here to return to the Sources section.

The Sawtooth Wave block generates a sawtooth wave (or saw wave) at a constant level and frequency. The output frequency is adjustable. Use the edit control or arrows to set the desired frequency; the checkbox control turns the signal on and off.. The gain and the initial phase of the algorithm can be configured.

To change the source's Sampling Rate, Right-click in the block and select Set Sampling Rate, which will open the Sampling Rate window (default is 44.1 kHz).

GUI Control

GUI Control NameDefault ValueRangeFunction Description
on/offoffon/offTurns the output of the cell on or off. When the output is off, the output pin will output a constant value of 0.
Frequency500.010.01 to 0.5*Sample RateThe sets the frequency of the sawtooth that is output from the cell.
Initial Phase00 to 360Initial Phase of the sawtooth signal.
Gain0-144 to 42 dB / -134 to 24 db The gain to be multiplied on the sawtooth wave


This module can be grown to support multiple phase/gain values for a single sawtooth wave.

resources/tools-software/sigmastudio/toolbox/sources/sawtoothwavewithphaseandgain.txt · Last modified: 06 Sep 2016 13:37 by Venkatesan Krishnamoorthy