This version (06 Aug 2012 22:16) was approved by Brett Gildersleeve.

Seven Band Level Detector

Click here to return to the Level Detectors/Lookup Tables page

The Seven-Band Level Detector block calculates the input signal level, reading directly from the hardware in real time, and displays the level graphically in seven frequency band meter displays:

  • <100Hz
  • 250Hz
  • 500Hz
  • 1kHz
  • 2.5kHz
  • 5kHz
  • >10kHz

The level detector performs analysis only and does not modify the input signal. The signal at the output pin is identical to the input.

Use the On / Off button to enable or disable the display. The level detector will not function until the schematic design has been compiled and downloaded to the hardware and a USB communication channel is properly configured.

Note: The refresh rate of the display is approximately 10 Hz. The display's performance is limited by your PC system and USB bandwidth. Using multiple level detectors may degrade the responsiveness.

resources/tools-software/sigmastudio/toolbox/leveldetectorslookuptables/sevenbandleveldetector.txt · Last modified: 06 Aug 2012 22:16 by Brett Gildersleeve