This version (03 Feb 2021 22:52) was approved by Michael Bradley.The Previously approved version (14 Jan 2021 05:24) is available.
Table of Contents
nanoDAC+ Evaluation Board Programmer
Overview
The nanoDAC+ Evaluation Board Programmer can be used to program the evaluation board ID on a selection of nanoDAC+ evaluation boards for use with legacy evaluation software or ACE evaluation software. The evaluation kits which this program can be used for are listed below, all other nanoDAC+ evaluation kits are already compatible with both evaluation platforms.
Installing the Software
ACE or legacy evaluation software must already be installed on the PC before installing the nanoDAC+ Evaluation Board Programmer.
- Download the nanoDAC+ Evaluation Board Installer from here.
- Unzip the files and run setup.exe
- Follow the installation instructions.
Running the Software
There must only be one System Demonstration Platform (SDP) Board Connected to the PC when running the software.
- Connect the evaluation board to the SDP as described in the Evaluation Kit User Guide.
- To run the software, click Start → All Programs → Analog Devices → Nanodac+ Evaluation Board Programmer → Nanodac+ Evaluation Board Programmer.
- Click Continue to continue.
- If nanoDAC+ evaluation board is not found, the below message will appear. Reset the SDP board and wait for 30 seconds before clicking OK. Click Cancel to exit the software.
- When the evaluation board is identified by the software, a prompt will appear for the user to select the evaluation software to reprogram the board to.
- Select the evaluation platform, and confirm in the following window.
- When programming is complete, it is reported to the user.
- Click OK to close the application.
Evaluation board is now ready for use with the selected evaluation platform.
resources/eval/user-guides/nanodac.txt · Last modified: 03 Feb 2021 22:52 by Michael Bradley