| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| resources:eval:user-guides:inertial-mems:imu:adis1646x [06 Oct 2014 22:46] – [EXAMPLE EXERCISES] Scott Hutchens | resources:eval:user-guides:inertial-mems:imu:adis1646x [28 Mar 2015 01:23] – [EVAL-ADIS: PC EVALUATION] Mark Looney |
|---|
| ====== ADIS1646X EVALUATION ON THE EVAL-ADIS ====== | ====== PC-BASED ADIS1646X EVALUATION ====== |
| |
| ===== OVERVIEW ===== | ===== OVERVIEW ===== |
| |
| The [[adi>ADIS16460|ADIS16460]] iSensor® device is a complete inertial system that includes a triaxial gyroscope and a triaxial accelerometer. Each sensor in the [[adi>ADIS16460|ADIS16460]] combines industry-leading iMEMS® technology with signal conditioning that optimizes dynamic performance. The factory calibration characterizes each sensor for sensitivity, bias and alignment. As a result, each sensor has its own dynamic compensation formulas that provide accurate sensor measurements. | Insert product picture, with key feature annotations |
| |
| The ADIS1646x is a low-profile, compact IMU that uses a serial peripheral interface (SPI) for data communications. This interface enables direct connection with a large variety of embedded processor products. This electrical connection typically only requires 5 I/O lines for synchronous data collection, as shown in the following figure: | |
| |
| {{:resources:eval:user-guides:inertial-mems:imu:460-spi-lines.png?400|}} | ===== SUMMARY ===== |
| | Brief description of the parts required to evaluate product with a PC |
| |
| |
| |
| ===== ADIS1646x/PCB BREAKOUT BOARD ===== | |
| For those who are on a tight timeline, connecting the [[adi>ADIS16460|ADIS16460]] to an embedded controller will provide the most flexibility in developing application firmware and will more closely reflect the final system design. The [[adi>en/evaluation/eval-adis16imu3/eb.html#buy|ADIS16IMU3/PCBZ]] is the breakout board for the [[adi>ADIS16460|ADIS16460]] and may provide assistance in the process of hooking it up to an existing embedded processor system. | |
| |
| |
| {{:resources:eval:user-guides:inertial-mems:imu:adis16imu3-parts.png?400|}} | |
| |
| |
| ===== EVAL-ADIS: PC EVALUATION ===== | |
| |
| For those who would prefer to perform PC-based evaluation of the ADIS1646x products, before developing their own embedded system, the [[adi>EVAL-ADIS|EVAL-ADIS]] is the appropriate system to use. The remainder of this Wiki site will focus on PC-based evaluation with the [[adi>EVAL-ADIS|EVAL-ADIS]] system. Here is a list of equipment required for this: | |
| |
| [[adi>EVAL-ADIS|EVAL-ADISZ]] | |
| |
| [[adi>adis16460|ADIS16460AMLZ]] | |
| |
| [[adi>en/evaluation/eval-adis16imu3/eb.html#buy|ADIS16IMU3/PCBZ]] | |
| |
| |
