Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
resources:eval:user-guides:inertial-mems:gyroscopes:adis16130-eval-adis [09 Jan 2021 00:39] – user interwiki links Robin Getzresources:eval:user-guides:inertial-mems:gyroscopes:adis16130-eval-adis [11 Feb 2021 17:55] (current) Ioana Chelaru
Line 1: Line 1:
-===== ADIS16130 EVALUATION ON THE EVAL-ADIS =====+f===== ADIS16130 EVALUATION ON THE EVAL-ADIS =====
 ==== INTRODUCTION ==== ==== INTRODUCTION ====
 The purpose of this Wiki Guide is to describe an approach to use for evaluating the [[adi>ADIS16130|ADIS16130]] on the [[adi>EVAL-ADIS|EVAL-ADIS]] evaluation system.  Although the [[adi>ADIS16130|ADIS16130]] package and electrical connector would support physical connection with the [[adi>EVAL-ADIS|EVAL-ADIS]], its pin assignment, SPI protocol, data format and operation prevent compatibility with the IMU Evaluation software package.   The purpose of this Wiki Guide is to describe an approach to use for evaluating the [[adi>ADIS16130|ADIS16130]] on the [[adi>EVAL-ADIS|EVAL-ADIS]] evaluation system.  Although the [[adi>ADIS16130|ADIS16130]] package and electrical connector would support physical connection with the [[adi>EVAL-ADIS|EVAL-ADIS]], its pin assignment, SPI protocol, data format and operation prevent compatibility with the IMU Evaluation software package.  
Line 204: Line 204:
  
  
-Take note of the clamps that are on the interface board, but not on the [[adi>adis16130||ADIS16130]].  In some cases, clamping the [[adi>adsi16130|ADIS16130]] down to the board will be necessary, due to the vibration in the oven.  This was not important for this exercise, but can be influential when developing fixtures for calibration systems. +Take note of the clamps that are on the interface board, but not on the [[adi>adis16130||ADIS16130]].  In some cases, clamping the [[adi>adis16130|ADIS16130]] down to the board will be necessary, due to the vibration in the oven.  This was not important for this exercise, but can be influential when developing fixtures for calibration systems. 
  
 The following table illustrates the thermal profile for the temperature chamber for this experiment. For those who are developing calibration systems, the dwell times and ramp rates are likely to be an area for application-specific optimization.   The following table illustrates the thermal profile for the temperature chamber for this experiment. For those who are developing calibration systems, the dwell times and ramp rates are likely to be an area for application-specific optimization.  
resources/eval/user-guides/inertial-mems/gyroscopes/adis16130-eval-adis.txt · Last modified: 11 Feb 2021 17:55 by Ioana Chelaru