Wiki

Analog Devices Wiki

English
English
简体中文
简体中文
日本語
日本語
Руccкий
Руccкий
This version is outdated by a newer approved version.DiffThis version (18 Jan 2013 03:25) is a draft.
Approvals: 0/1

This is an old revision of the document!

Table of Contents

How to Install Drivers (Without an Installer)

This page describes how to install drivers without an installer, as in the case of the ADXL362 Datalogger / Development Board.

The installation shown on this page was performed on a Windows 7 machine. The specifics may be slightly different on your system, but the general procedure is the same.

Windows 7

  1. Connect the board to your computer via a USB cable.
  2. If prompted to install drivers (you will be unless you've already completed this procedure), choose Install from a list or specific location (Advanced), then click Next.
  3. Select Don't search. I will choose the driver to install, then click Next.
  4. Select Ports (COM & LPT), and click Next.

  5. Click Have Disk….

  6. On the screen that opens, select Browse…

  7. Navigate to the .inf file on your hard drive or CD.

  8. Click Open, then in the Install From Disk prompt, click OK.

  9. Select “ADI Inertial Sensor Development Board” in the Model list, and click Next >.

  10. Respond Continue Anyway or Install to the warning.

  11. Click Finish to complete the USB driver installation.

Windows Vista

Windows XP

  1. Connect the board to your computer via a USB cable.
  2. If prompted to install drivers (you will be unless you've already completed this procedure), choose Install from a list or specific location (Advanced), then click Next.
  3. Select Don't search. I will choose the driver to install, then click Next.
  4. Select Ports (COM & LPT), and click Next.
  5. Click Have Disk…. On the screen that opens, select Browse… and navigate to the .inf file on your hard drive or CD.
  6. Click Open, then in the Install From Disk prompt, click OK.
  7. Select “ADI Inertial Sensor Development Board” in the Model list, and click Next >.
  8. Respond Continue Anyway to the warning.
  9. Click Finish to complete the USB driver installation.
resources/eval/user-guides/inertial-mems/evalsystem/installdrivers.1358475943.txt.gz · Last modified: 18 Jan 2013 03:25 by Nitzan Gadish

Page Tools