This is an old revision of the document!
EVAL-ADSD3100-NXZ Startup Guide
Kit Contents
Startup
Connect
USB-C cable to module
-
Wait for green light under the
USB-C connector on the module light up
-
If mp_pcm mode does not work (ie.
GUI is stuck/crashes), disconnect
USB-C Cable from laptop. Connect module to
USB-C hub 5Gbps port (highlighted by white box), and connect hub to pc. Restart the
GUI and try again.
Troubleshooting
-
Green light under
USB-C Connector not turning on
SD-Card could be corrupted. 'Firmware Flashing Link'