This version (12 Feb 2019 00:22) was approved by Sundar Palani.

EVAL-ADPAQ3029 - HC-SR04 demo

Download firmware and Tile application from below

HC-SR04 Firmware

Tile GUI application
Follow the same steps as given here
In this project, an Ultrasonic Sensor – HC-SR04 has been used.
The connections between the Ultrasonic Sensor and ADPAQ module are made as described in the table below.

HC-SR04 Pins GPIO port used ADPAQ Header Pins

Vcc 3.3V P1-3.3V

Trig P0_0 P2-5

Echo P2_1 P3-1

Gnd GND P1-GND_POWER
Build and run the project
The Ultrasonic Sensor measurement is displayed on tile in “cm”.

Wiki