This version is outdated by a newer approved version.
This version (10 Oct 2016 12:43) is a draft.
Approvals: 0/1
This version (10 Oct 2016 12:43) is a draft.Approvals: 0/1
This is an old revision of the document!
Table of Contents
EVAL-CN0391-ARDZ Shield
The EVAL-CN0391-ARDZ shield is a single supply, multi channel thermocouple temperature meter. The CN0391 uses AD7124-8 8-Channel, Low Noise, Low Power, 24-Bit, Sigma-Delta ADC with PGA and Reference as integrated solution for multi channel thermocouple temperature measurement with RTD cold junction compensation.
<picture>
Equipment Needed
- EVAL-CN0391-ARDZ Circuit Evaluation Board
- EVAL-ADICUP360 Development Board or compatible Arduino platform Board.
- B, E, J, K, N, R, S, T type thermocouples, each type 4 pieces
- PC with Microsoft Windows 7 64bit or later and USB2.0 port or higher
- Serial terminal software
General Setup
- Connect the EVAL-CN0391-ARDZ to EVAL-ADICUP360 board
- Connect 4 thermocouples to EVAL-CN0391-ARDZ P1~P4, marked on PCB with CH0~CH3
- Connect the EVAL-ADICUP360 USER USB port to PC with USB cable
Connectors and Jumper Configurations
To use the EVAL-CN0391-ARDZ please connect the thermocouples to each channel and set the software to corresponding thermocouple type. Please set the jumper as following picture:
picture
Schematic, PCB Layout, Bill of Materials
Software
resources/eval/user-guides/eval-adicup360/hardware/cn0391.1476096221.txt.gz · Last modified: 10 Oct 2016 12:43 by Robert Lee