Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
resources:eval:user-guides:eval-ad5940:software_examples:ad5940_ramp [08 Jul 2019 17:28] Micheál Lambe |
resources:eval:user-guides:eval-ad5940:software_examples:ad5940_ramp [22 Oct 2019 17:03] Micheál Lambe |
||
|---|---|---|---|
| Line 29: | Line 29: | ||
| - Set S5 to Wall/USB to power the board from the USB cable{{ :resources:eval:user-guides:eval-adicup3029:reference_designs:img_20170612_144023_hdr.jpg?800 |}} | - Set S5 to Wall/USB to power the board from the USB cable{{ :resources:eval:user-guides:eval-adicup3029:reference_designs:img_20170612_144023_hdr.jpg?800 |}} | ||
| - Place the **EVAL-AD5940ELCZ** on top of the **EVAL-ADICUP3029**. | - Place the **EVAL-AD5940ELCZ** on top of the **EVAL-ADICUP3029**. | ||
| - | - Ensure jumper on JP10 and JP11 is on PIN2 and PIN4 (to use the USB connected probe with EVAL-AD5940ELCZ, JP9,JP10 and JP11 should be configured to position C - pins 5 and 6) | + | - Ensure jumper on JP10 and JP11 is on PIN2 and PIN4 to connect the dummy sensor to the AD5940 (to use the USB connected probe with EVAL-AD5940ELCZ, JP9,JP10 and JP11 should be configured to position C - pins 5 and 6) |
| - | - Place jumper in position B on JP6 to connect the 1kΩ||3kΩ RE0 and SE0 | + | - Place jumper in position B on JP6 to connect the 10kΩ||10kΩ resistor divider between RE0 and SE0 |
| - Plug in the micro USB cable into the (P10) USB port on the EVAL-ADICUP3029, and the other end into the PC or laptop. | - Plug in the micro USB cable into the (P10) USB port on the EVAL-ADICUP3029, and the other end into the PC or laptop. | ||
resources/eval/user-guides/eval-ad5940/software_examples/ad5940_ramp.txt · Last modified: 22 Oct 2019 17:03 by Micheál Lambe