EV-COG-AD3029WZ with IAR Embedded Workbench for ARM
There are no seperate toolchain,On-Board Peripheral Drivers & Software for EV-COG-AD3029WZ, the toolchain,On-Board Peripheral Drivers & Software for EV-COG-AD3029LZ works with EV-COG-AD3029WZ.The user needs to change only the pin muxing based on the application.For help regarding pinmapping refer to the Hardware Details section.
First, install mBed windows serial driver from https://developer.mbed.org/handbook/Windows-serial-configuration
IDE Setup
Install IAR Embedded Workbench for ARM
Please visit
https://www.iar.com/ to download IAR Embedded Workbench for ARM (version 8.20.1 or above)
License Installation
Software Packs and Driver Setup
Download the following packs for EV-COG-AD3029LZ (The packs are same for EV-COG-AD3029LZ and EV-COG-AD3029WZ)
Start IAR Embedded Workbench for ARM.
Go to Project→ CMSIS-Pack→ Pack Installer.

In
'CMSIS Pack Manager' window, click 'Install local pack file'.

In 'Pack file to install' window navigate to the downloaded pack (as already done in step 1 of this section), select all the packs to install and click Open.

Running an Example Project
Power the MCU Cog using a
USB (micro-B) Cable. You should see a red LED and a yellow LED turn on by default.

In IAR
IDE, go to Project→ Create New Project…

In
'Create New Project' window, Select
'CMSIS Pack Example' and click 'OK'.

Expand Analog Devices, select
ADuCM3029 and click 'Next'.

Select
button_press example and click 'Finish'.

Save the project to the desired location.
Click on 'Debug and Download' icon

on the menu bar. This will compile, build and download the project on EV-COG-AD3029WZ using CMSIS-DAP.
Click on 'Run' icon

to start the debug session.
Now press BTN1 or BTN2 on EV-COG-AD3029WZ and inspect corresponding LED
You are all set!
Back