Wiki

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
resources:eval:user-guides:ev-cog-ad3029lz:help_support [12 Aug 2017 08:28]
Pranit Jadhav [What to do When Things Go Wrong]
resources:eval:user-guides:ev-cog-ad3029lz:help_support [03 Jan 2021 21:55]
Robin Getz fix links
Line 17: Line 17:
     * The first thing to try in this case, is to [[resources:​eval:​user-guides:​ev-cog-ad3029lz:​tools:​hardware_usb|drag and drop]] a known good .HEX or .BIN program into flash.(something with quick visible indicators works best)     * The first thing to try in this case, is to [[resources:​eval:​user-guides:​ev-cog-ad3029lz:​tools:​hardware_usb|drag and drop]] a known good .HEX or .BIN program into flash.(something with quick visible indicators works best)
     * If drag and drop is not working, it may be necessary to erase the flash. To do so:  ​     * If drag and drop is not working, it may be necessary to erase the flash. To do so:  ​
-      - Download and install the CrossCore Serial Flash Programmer from here: [[http://​www.analog.com/​en/​design-center/​processors-and-dsp/​evaluation-and-development-software/​crosscore-serial-flash-programmer.html#​dsp-overview]].  ​+      - Download and install the CrossCore Serial Flash Programmer from here: [[adi>en/​design-center/​processors-and-dsp/​evaluation-and-development-software/​crosscore-serial-flash-programmer.html#​dsp-overview]].  ​
       - Make sure that the USB is connected and on UART header (P8) 1 & 2 and 7 & 8 are shorted. ​       - Make sure that the USB is connected and on UART header (P8) 1 & 2 and 7 & 8 are shorted. ​
       - Power cycle the EV-COG-AD3029LZ board while holding down the boot switch. ​       - Power cycle the EV-COG-AD3029LZ board while holding down the boot switch. ​
Line 27: Line 27:
   - Not receiving/​transmitting data to the UART   - Not receiving/​transmitting data to the UART
     * Make sure that the UART header (P8) is positioned in the correct destination to transmit/​receive UART data.     * Make sure that the UART header (P8) is positioned in the correct destination to transmit/​receive UART data.
 +    * JH6 is shorted.
   ​   ​
 This is just a brief self-help guide to troubleshooting common issues. ​ If you have other questions that need answering please direct those requests to the locations outlined below. This is just a brief self-help guide to troubleshooting common issues. ​ If you have other questions that need answering please direct those requests to the locations outlined below.
resources/eval/user-guides/ev-cog-ad3029lz/help_support.txt · Last modified: 03 Jan 2021 21:55 by Robin Getz