Differences

This shows you the differences between two versions of the page.

--- resources:eval:user-guides:circuits-from-the-lab:eval-adxl355-pmdz [12 Apr 2023 02:40] – [Additional Information and Useful Links] Trisha Cabildo
+++ resources:eval:user-guides:circuits-from-the-lab:eval-adxl355-pmdz [20 Apr 2023 08:03] (current) – update Trisha Cabildo
@@ Line 232: / Line 232: @@
 To set up the circuit for evaluation, consider the following steps:
   - Connect the **P9** of the **PMOD to Raspberry Pi Interposer** board at the male header GPIO pin connector of the **Raspberry Pi** as shown below. {{ :resources:eval:user-guides:circuits-from-the-lab:cn0552:interposer.png?500 | }}
-  - Connect the ** [[ADI>EVAL-ADXL355-PMDZ|EVAL-ADXL355-PMDZ]] ** on the PMOD to Raspberry Pi Interposer board either via Port P3 or P4. {{ :resources:eval:user-guides:circuits-from-the-lab:eval-adxl355-pmdz:adxl355_rpi_connections.jpg?600 | }}
+  - Connect the ** [[ADI>EVAL-ADXL355-PMDZ|EVAL-ADXL355-PMDZ]] ** on the PMOD to Raspberry Pi Interposer board either via Port P1 or P2. {{ :resources:eval:user-guides:circuits-from-the-lab:eval-adxl355-pmdz:adxl355_rpi_connections.jpg?600 | }}
   - Burn the SD card with the proper ADI Kuiper Linux image. Insert the burned SD card on the designated slot on the RPi.
   - Connect the system to a monitor using an HDMI cable through the mini HDMI connector on the RPi.

Wiki