Wiki

This version is outdated by a newer approved version.DiffThis version (06 Feb 2020 17:05) was approved by Stanca-Florina Pop.The Previously approved version (10 Jan 2018 21:08) is available.Diff

This is an old revision of the document!


CN0332 Evaluation Board Guide

This product is obsolete, and this page is only for documentation and support.

Overview

CN0332 is a single-supply low cost, high-speed magnetoresistive (MR) signal conditioner with a minimum PCB footprint. The complete signal conditioning solution amplifies the small output voltage of the magnetoresistive sensor and converts it into a digital output signal with a rise and fall time of less than 5 ns and an rms jitter of approximately 100 ps. The circuit provides a compact and cost effective robust solution for high speed rotational sensing in industrial and automotive applications and is an excellent alternative to Hall effect sensors.

The AA747 Sensitec MR Sensor has a typical bridge output voltage of 30 mV p-p to 100 mV p-p at a common-mode voltage that is equal to one-half the supply voltage. The bridge output impedance is approximately 3 kΩ

The ADA4897-2 dual op amp has a high bandwidth (230 MHz for G = +1) and a rail-to-rail input and output making it an ideal buffer for the sensor signal. Voltage noise is only 1 nV/√Hz.

The AD8027 is also a high bandwidth (190 MHz, G = +1) rail-to-rail amplifier with a slew rate of 100 V/μs. It is stable at high gains and is ideally suited to be configured as a difference amplifier of the small signal output of magnetoresistive sensors.

The ADCMP601, a very fast single supply rail-to-rail TTL/CMOS comparator with a propagation delay of only 3.5 ns and a minimum pulse width of 3 ns, converts the amplified small signal voltage to a digital signal.

The ADP1720 low dropout linear regulator is used to isolate the circuit from noise that can occur in harsh environments.

The CN0332 needs a single +5.5 V up to +28 V power supply input and has a PMOD interface.


Required Equipment

  • EVAL-CN0332-PMDZ Evaluation Board
  • +6 V/1 A DC Power Supply

General Setup

Block Assignments

  • The EVAL-CN0332-PMDZ is powered by a 5.5 V power supply input (up to 28 V) that connects to pin 6 and pin 12 of the PMOD interface
  • The digital output signal from the ADCMP601 is connected to pin 4 of the PMOD interface
  • SHORTING Jumper P2 will remove the hysteresis of the ADCMP601 output while OPENING it will enable a fixed hysteresis on the comparator

Schematic, PCB Layout, Bill of Materials

EVAL-CN0332-PMDZ Design & Integration Files

  • Schematics
  • PCB Layout
  • Bill of Materials
  • PADS project

End of Document

resources/eval/user-guides/circuits-from-the-lab/cn0332.1580979812.txt.gz · Last modified: 06 Feb 2020 10:03 by Stanca-Florina Pop