This version is outdated by a newer approved version.
This version (22 Aug 2019 10:06) was approved by Adrian Costina.The Previously approved version (09 Aug 2019 14:28) is available.
This version (22 Aug 2019 10:06) was approved by Adrian Costina.The Previously approved version (09 Aug 2019 14:28) is available.This is an old revision of the document!
Table of Contents
ADRV9009 Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
Supported Environments
The supported OS are:
Hardware Setup
In most carriers, the ADRV9009-W/PCBZ, ADRV9008-1W/PCBZ and ADRV9008-2W/PCBZ boards connects to the HPC1 connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
ZCU102 + ADRV9009/PCBZ
Unboxing guide
resources/eval/user-guides/adrv9009/quickstart.1566461176.txt.gz · Last modified: 22 Aug 2019 10:06 by Adrian Costina