This version is outdated by a newer approved version.
This version (25 Mar 2016 18:23) was approved by Neil Wilson.The Previously approved version (25 Mar 2016 18:07) is available.
This version (25 Mar 2016 18:23) was approved by Neil Wilson.The Previously approved version (25 Mar 2016 18:07) is available.This is an old revision of the document!
Table of Contents
Introduction
The AD-TRXBOOST1-EBZ module is comprised of the ADL5610 which is an 18dB RF fixed gain block that can operate between 30MHz and 6 GHz with a low noise figure of 2.2dB, the ADL5521 which is a 20dB LNA that can operate between 400MHz and 4GHz with a low noise figure of 0.8dB, along with the ADP2370 switch regulator and two ADP7104 LDOs.
For additional information or to purchase the AD-TRXBOOST1-EBZ, visit: www.analog.com/AD-TRXBOOST1-EBZ
Features
- Includes schematics, layout, BOM, Gerber files
- Powered from single Keyed connector that matches the header on the FMCOMMS2/3/4 series.
- Provides one channel TX and one channel RX boost.
ADL5610 Gain Block
- 30MHz to 6 GHz
- Fixed gain of 18.4dB
- Noise figure: 2.2dB at 900MHz
- OIP3: 38.8dBm at 900MHz
- P1dB: 20.4dBm at 900MHz
- Single 5V supply
ADL5521 LNA
- 400MHz to 4GHz
- Fixed gain of 20.8dB at 900MHz
- Noise figure: 0.8dB at 900MHz
- OIP3: 37.0dBm at 900MHz
- P1dB: 21.8dBm at 900MHz
- Single supply between 3V and 5V
Applications
- Electronic test and measurement equipment
- General-purpose software radios
- Radar systems
- Ultra wideband satellite receivers
- Signals intelligence (SIGINT)
- Point to point communication systems
- DOCSIS 3.0 CMTS and HFC networks
- Multiple input/multiple output (MIMO) radios
- Automated test equipment
Navigation - AD-TRXBOOST1-EBZ
resources/eval/user-guides/ad-trxboost1-ebz/introduction.1458926320.txt.gz · Last modified: 25 Mar 2016 18:18 by Neil Wilson