This version is outdated by a newer approved version.
This version (17 Apr 2015 16:19) was approved by Dragos Bogdan.The Previously approved version (17 Apr 2015 14:06) is available.
This version (17 Apr 2015 16:19) was approved by Dragos Bogdan.The Previously approved version (17 Apr 2015 14:06) is available.This is an old revision of the document!
Table of Contents
AD-FMCOMMS2/3/4/5-EBZ Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD-FMCOMMS2/3/4/5-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The AD-FMCOMMS2/3/4/5-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
Supported Environments
The supported OS are:
Hardware Setup
In most carriers, the AD-FMCOMMS2/3/4-EBZ board connects to the LPC connector (unless otherwise noted). The AD-FMCOMMS5-EBZ board is a dual FMC connector, and requires either FMC connectors (which can be either LPC + LPC). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
ZC706 + FMCOMMS2
SoCkit + ARRADIO
Jumper Configuration
| CLOCKSEL0 | CLOCKSEL1 | BOOTSEL0 | BOOTSEL1 | BOOTSEL2 | |
|---|---|---|---|---|---|
| POS | 2-3 | 2-3 | 2-3 | 2-3 | 1-2 |
| JP2 |
|---|
| 1.8V or 2.5V |
| MSEL0 | MSEL1 | MSEL2 | MSEL3 | MSEL4 | CODEC_SEL | |
|---|---|---|---|---|---|---|
| POS | 0 | 0 | 1 | 0 | 0 | 0 |
resources/eval/user-guides/ad-fmcomms2-ebz/quickstart.1429280381.txt.gz · Last modified: 17 Apr 2015 16:19 by Dragos Bogdan