Wiki

Below is the source of this page. To edit this source as well as other pages on the wiki, you must login.

===== AD-FMCOMMS11-EBZ Quick Start Guides =====

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD-FMCOMMS2/3/4/5-EBZ boards on various FPGA development boards. These discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

==== Supported Carriers ====

The AD-FMCOMMS11EBZ is, by definition a "FPGA mezzanine card" (FMC), that means it needs a carrier to plug into. The carrier currently supported is [[xilinx>ZC706]]  via the high pin count (HPC) connector.

==== Hardware Setup ====

The AD-FMCOMMS11-EBZ board connects to the HPC connector. The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.

=== ZC706 + FMCOMMS11 ===
{{ :resources:eval:user-guides:ad-fmcomms11-ebz:fmcomms11_zc706.jpg?800 |}}

To boot from SD card, make sure that the SW11 switches of ZC706 is configured as shown below.
{{ :resources:eval:user-guides:ad-fmcomms11-ebz:zilynx_switch_settings.png?200 |}}

Analog Devices Wiki

Page Tools