This version is outdated by a newer approved version.
This version (30 Mar 2015 14:34) was approved by Andrei Cozma.The Previously approved version (20 Feb 2015 09:34) is available.
This version (30 Mar 2015 14:34) was approved by Andrei Cozma.The Previously approved version (20 Feb 2015 09:34) is available.This is an old revision of the document!
Table of Contents
AD-FMCMOTCON2-EBZ Linux on Zynq Quick Start Guide
This guide provides some quick instructions (still takes awhile to download, and set things up) on how to setup the AD-FMCMOTCON2-EBZ on either:
- ZED Board, Rev C or later
Requirements
- You need a Host PC (Windows or Linux).
- You need a SD card writer connected to above PC (Supported USB SD readers/writers are OK).
- USB keyboard/mouse for the Zynq Device
- HDMI Display (monitor or TV)
Creating the SD Card
Connecting the hardware together
Instruction regarding the hardware connection can be found at:
Hardware connection user guide ZED board
Booting the SD Card
- ignore your PC, and now interact on the USB mouse/keyboard on the Zynq device
- You should see two screens:
- firefox:
- Learn more about the network interface.
- IIO Scope tool:
- Learn more about the IIO Scope.
- You are now done with booting from the SD card. You can interact with the GUI either over the network, or with the HDMI monitor/USB keyboard mouse.
Using IIO SCOPE for AD-FMCMOTCON2-EBZ
Even thought this is Linux, this is a persistent file system. Care should be taken not to corrupt the file system -- please shut down things, don't just turn off the power switch. Depending on your monitor, the standard power off could be hiding. You can do this from the terminal as well with:
sudo shutdown -h now
Navigation - AD-FMCMOTCON2-EBZ
Up: Overview
resources/eval/user-guides/ad-fmcmotcon2-ebz/quickstart/zynq.1427718829.txt.gz · Last modified: 30 Mar 2015 14:33 by Andrei Cozma