Analog.com
Engineer
Zone
Analog
Dialogue
Log In
<- Return to previous page
Company
Products
Applications
Design Center
Education
Support
Engineer
Zone
Analog
Dialogue
Wiki
Wiki
Resources and Tools
Evaluation Boards & Kits
FPGA Reference Designs
Quick Start Guides
Linux Software Drivers
Microcontroller Software Drivers
ACE Software
Technical Guides
Education Content
University Program Overview
ADALM1000 (M1k) Active Learning Module
ADALM2000 (M2k) Active Learning Module
ADALP2000 Parts kit for Circuits
ADALM-PLUTO SDR Active Learning Module
Teaching and Lab Materials
Wiki Help
Help
About Wiki
Playground
Wiki Site Map
Wiki Tools
Admin
Recent Changes
Media Manager
Sitemap
Analog Devices Wiki
Analog Devices Wiki
Resources and Tools
Evaluation Boards & Kits
FPGA Reference Designs
Quick Start Guides
Linux Software Drivers
Microcontroller Software Drivers
ACE Software
Technical Guides
Education Content
University Program Overview
ADALM1000 (M1k) Active Learning Module
ADALM2000 (M2k) Active Learning Module
ADALP2000 Parts kit for Circuits
ADALM-PLUTO SDR Active Learning Module
Teaching and Lab Materials
Wiki Help
Help
About Wiki
Playground
Wiki Site Map
Wiki Tools
Admin
Recent Changes
Media Manager
Sitemap
This version (
07 Jul 2014 10:10
) was
approved
by
Andrei Cozma
.
The
Previously approved version
(11 Jun 2014 16:38) is available.
Table of Contents
DYNO test procedure
Required hardware
Test Procedure
DYNO test procedure
Required hardware
ZedBoard with mouse and keyboard
SD
card with
ADI
Linux image
HDMI monitor
AD-FMCMOTCON1-EBZ
AD-DYNO1-EBZ
Test Procedure
Connect the hardware as shown in this video:
Hardware Connection
In the Linux IIO scope go to the
Motor Control
tab and select the following configuration:
Delta
: ON
Direction
: Clockwise
Sensors
: hall
Controller type
: Manual PWM
PWM
: 90.96%
Set
Run
to ON
Make sure that there are no vibrations in the DYNO system.
On the DYNO board open the
Measurements
menu
Check the speed & current displayed under
Measurements
on the DYNO LCD to see if it reads 5300rpm +/- 250rpm for speed and 0.3A for current
Set the load to 100%
Check the speed & current displayed under
Measurements
on the DYNO LCD to see if it reads 3900rpm +/- 250rpm for speed and 1.5A +/- 0.1A for current
resources/eval/user-guides/ad-fmcmotcon1-ebz/hardware/dyno_test.txt
· Last modified: 07 Jul 2014 10:10 by
Andrei Cozma
Page Tools
View Source
History
Backlinks
Fold/unfold all
[ Back to top ]