Wiki

This version (12 Jun 2018 15:03) was approved by Charly El-Khoury.

AD-FMCDAQ3-EBZ Quick Start Guides

The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD-FMCDAQ3-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

Supported Carriers

The AD-FMCDAQ3-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board AD-FMCDAQ3-EBZ
A10GX v
KCU105 v
ZC706 v
ZCU102 v

The supported OS are:

Board Linux Software No-OS Software
A10GX v v
KCU105 v v
ZC706 v v
ZCU102 v v

Hardware Setup

In most carriers, the AD-FMCDAQ3-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A typical setup is shown below.

resources/eval/user-guides/ad-fmcdaq3-ebz/quickstart.txt · Last modified: 12 Jun 2018 12:57 by Andrei Grozav