Wiki

This version (28 Oct 2016 15:54) was approved by Lucian Sin.The Previously approved version (25 Feb 2016 14:22) is available.Diff

AD-FMCADC4-EBZ Quick Start Guides

The Quick Start Guides provide a simple step by step instructions on how to do an initial system setup for the AD-FMCADC4-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.

Supported Carriers

The AD-FMCADC4-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:

Board AD-FMCADC4-EBZ
ZC706

The supported OS are:

Board HDL Linux Software No-OS Software
ZC706 -

Hardware Setup

In most carriers, the AD-FMCADC4-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A typical setup is shown below.

resources/eval/user-guides/ad-fmcadc4-ebz/quickstart.txt · Last modified: 28 Oct 2016 15:11 by Lucian Sin