Wiki

Below is the source of this page. To edit this source as well as other pages on the wiki, you must login.
====== Windows User Guide ======

{{page>./ug_host_system_setup}}

==== Enable the USB connection to the host PC ====
  * After the DragonBoard boots up press the S3 button on the camera board. This will start on the DragonBoard the application that manages the USB host interface
  * Once the USB connection is active the DS4 LED will light up on the camera board and the USB camera driver will be loaded on the PC enabling the communication between the host PC and the camera system. The ADI TOF DEPTH SENSOR may also show up under Cameras instead of Imaging devices.

{{ :resources:eval:user-guides:ad-96tof1-ebz:windows_db410c_usb.jpg?300 |Windows driver}}

==== Troubleshooting ====
  * The PC does not load the USB driver after pressing the S3 button on the camera board
    * Press S3 so that DS4 turns off, reconnect the USB cable to the PC into a different USB port, press S3 again so that DS4 turns on
    * Restart the DragonBoard410c while the USB cable is still connected to the host PC

----

==== Ethernet connection ====
  * The IP address of the target is needed in order to use the ethernet connection. To find the IP address, connect a keyboard, a mouse and a monitor to the camera. After booting open a terminal and type either **sudo ifconfig** or **ip addr** command.
  * There are two examples that show how to use the ethernet connection: **aditof-demo** and **first-frame-ethernet**.
  * For **first-frame-ethernet** example, if the IP address of the target is //192.168.1.110// the run command should be: <code>first-frame-ethernet.exe "192.168.1.110"</code>
  * In the **aditof-demo** example, choose to connect via ethernet from the UI. After the //Ethernet// checkbox is selected input the IP and press the button //Connect//.

{{ :resources:eval:user-guides:ad-96tof1-ebz:aditof-demo_ethernet.png?300 |aditof-demo connect through ethernet}}

----

===== Running the evaluation application =====

You can either build the evaluation application from source or install it using the [[https://github.com/analogdevicesinc/aditof_sdk/releases/latest|aditof-demo installer]]

Navigate to the location where you chose to install the evaluation application and run aditof-demo.exe. Alternatively, run the shortcut Aditof-Demo from desktop if you enabled the installer to create one. 

{{page>./ug_aditof_demo}}

{{navigation AD-96TOF1-EBZ#none#.:|Overview#none#}}
Analog Devices Wiki

Page Tools
