This version is outdated by a newer approved version.
This version (11 Jan 2020 05:02) was approved by Kristen Chong.The Previously approved version (05 Jan 2020 21:24) is available.
This version (11 Jan 2020 05:02) was approved by Kristen Chong.The Previously approved version (05 Jan 2020 21:24) is available.This is an old revision of the document!
Table of Contents
After 2020, we will begin to phase out the ADIS16448 IMU in favor of the newer ADIS16470 with better features. We strongly encourage teams that have not obtained one of the newer IMUs to consider getting one from FIRST Choice this year. The ADIS16448 IMU is still supported, but stock will be limited and library updates/releases for this device will be slower.
ADIS16448 IMU Board for FIRST Robotics
The ADIS16448 IMU board is ADI's rugged, tactical IMU designed for use in a wide variety of applications, including industrial robots, smart agriculture, and autonomous vehicles. The ADIS16448 is a 10 degree-of-freedom IMU, with 3-axis gyro, 3-axis accelerometer, 3-axis magnetometer, and a barometer.
ADIS16448 software and examples for Java, C+ +, and LabVIEW can be found here. If your team wants to use this board with other programming languages, please refer to the ADIS16448 product datasheet for more information on how to communicate with this IMU via SPI.
If you're looking for information on other ADI donation resources, click here to go back to the main page.
Getting Started
The ADIS16448 IMU Board is designed to plug directly into the MXP port on the RoboRIO. Due to the size of typical FRC robots, AHRS calculations that rely on the magnetometer may be adversely affected by motors and metal objects close to the sensor. The IMU board has two mounting holes which should be used to secure it to the RoboRIO with #4-40 screws. The figure to the right illustrates the X, Y, and Z axis relative to the device package. Note that the IMU is installed on the board upside down compared to the image shown here.
A Note on Offset Calibration
To help the robot minimize start-up drift and improve overall sensor performance, an offset calibration function has been built into the IMU driver. This function captures several seconds worth of data and calculates an average offset which is then applied to the sensor outputs. By default, calibration is automatically started once the RoboRIO begins executing user code and usually takes about 10 seconds to complete. If your IMU board has a “Ready?” LED indicator, it will illuminate once calibration is complete.
The gyros used in the ADIS16448 measure angular rate, not angle! Any movement during the offset calibration routine will introduce some error into every sensor measurement! Over time, this error, will appear as “drift” in your angle measurement. It is VERY important that the robot remains completely stationary during this calibration period!
Offset calibration should be performed as soon as the robot is powered on to prevent the routine from interfering with any autonomous code execution. If your gyro angle readings are drifting drastically, clicking Restart Robot Code in the driver station will force the RoboRIO to re-execute the offset calibration routine. This should fix any drift issues caused by a bad offset measurement.
Using the ADIS16448 IMU on Your Robot
For more information on how to add IMU functionality to your robot code, select your team's programming language from the list below.
Using the ADIS16448 IMU in LabVIEW
Using the ADIS16448 IMU in C++
Using the ADIS16448IMU in Java
first/adis16448_imu_frc.1578715374.txt.gz · Last modified: 11 Jan 2020 05:02 by Kristen Chong