Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| resources:tools-software:linux-drivers:gpio:adp5588-gpio [09 Nov 2011 11:54] – [Supported Devices] Michael Hennerich | resources:tools-software:linux-drivers:gpio:adp5588-gpio [05 Sep 2012 11:24] – ch Michael Hennerich | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ===== Evaluation Boards ===== | ===== Evaluation Boards ===== | ||
| - | * [[adi> | + | * [[adi> |
| - | * [[adi> | + | * [[adi> |
| - | * [[adi> | + | * [[adi> |
| ===== Description ===== | ===== Description ===== | ||
| Line 28: | Line 28: | ||
| ^ Source | ^ Source | ||
| - | | [[bfgit>linux-kernel?drivers/ | + | | [[git.linux.org>drivers/ |
| ===== Files ===== | ===== Files ===== | ||
| Line 66: | Line 66: | ||
| < | < | ||
| The ADP5588 Driver depends on **CONFIG_I2C**\\ | The ADP5588 Driver depends on **CONFIG_I2C**\\ | ||
| - | IRQ-Chip interrupt controller support is not available in case this driver is build as Module | + | IRQ-Chip interrupt controller support is not available in case this driver is build as Module |
| </ | </ | ||
| < | < | ||
| - | Device Drivers | + | Device Drivers |
| - | [*] GPIO Support | + | [*] GPIO Support |
| --- GPIO Support | --- GPIO Support | ||
| Line 109: | Line 109: | ||
| <note tip> | <note tip> | ||
| On the ADP5588 Demo Mother Board replace R30 (10kOhm PULL-UP resistor on /INTB strobe) with a 1-3kOhm resistor. | On the ADP5588 Demo Mother Board replace R30 (10kOhm PULL-UP resistor on /INTB strobe) with a 1-3kOhm resistor. | ||
| - | The 10kOhm resistor is too weak - Blackfin might see an additional falling edge interrupt on the rising edge of / | + | The 10kOhm resistor is too weak - Blackfin might see an additional falling edge interrupt on the rising edge of /INTB. |
| </ | </ | ||
resources/tools-software/linux-drivers/gpio/adp5588-gpio.txt · Last modified: 03 Jan 2013 20:42 by 127.0.0.1