Differences

This shows you the differences between two versions of the page.

--- resources:fpga:xilinx:pmod:adxl345 [30 Oct 2013 09:56] – [Preparing the SD Card] Alexandru.Tofan
+++ resources:fpga:xilinx:pmod:adxl345 [03 Sep 2014 18:48] – [Preparing the SD Card] Lars-Peter Clausen
@@ Line 162: / Line 162: @@
     * Configure the kernel to include the driver for the ADXL345: [[http://wiki.analog.com/resources/tools-software/linux-drivers/input-misc/adxl345|Compiling the ADXL345 driver into the kernel]]
     * Follow the instructions on the following wiki page, but use the device tree downloaded on the previous step and the kernel configuration above
-        * [[http://wiki.analog.com/resources/tools-software/linux-drivers/platforms/zynq?s=adv7511&s=linux|Linux with HDMI video output on the ZED and ZC702]].
+        * [[http://wiki.analog.com/resources/tools-software/linux-drivers/platforms/zynq|Linux with HDMI video output on the ZED and ZC702]]. When following those instructions make sure to copy the devicetree file that was downloaded in step 1) to arch/arm/boot/dts/zynq-zed-adv7511-pmod-acl.dts before trying to build the zynq-zed-adv7511-pmod-acl.dtb file.
 Make sure you have an HDMI monitor connected to the ZedBoard, plug in the SD Card and power on the board.

Wiki