This version is outdated by a newer approved version.
This version (12 Oct 2012 23:50) is a draft.
Approvals: 0/1The Previously approved version (28 Aug 2012 01:19) is available.
This version (12 Oct 2012 23:50) is a draft.Approvals: 0/1The Previously approved version (28 Aug 2012 01:19) is available.
This is an old revision of the document!
Table of Contents
ADXL362 Datalogger & Development Board
Thanks for visiting!
This page is UNDER CONSTRUCTION.
This page is UNDER CONSTRUCTION.
Resources
Kit Contents
1 x ADXL362 Datalogger / Development Board
1 x MicroSD card with USB reader
1 x USB cable
1 x E-Ink electronic paper display
1 x Piece of double-sided foam tape
Design and Integration Files
Programming Environment
The firmware for the EVAL-ADXL362Z-DB was developed for the Renesas RL78/G13 microcontroller using the Renesas Electronics CubeSuite+ environment. The links below offer downloads and installation instructions for these tools:
http://www.renesas.eu/products/tools/evaluation_software/downloads.jsp (Global site)
http://am.renesas.com/products/tools/evaluation_software/downloads.jsp (US site)
Getting Started
Using the Board
Firmware Options
Analog Devices has developed firmware for implementing the following functions via the EVAL-ADXL362Z-DB:
- Datalogger and GUI (includes real-time data viewer and tilt sensor): logs data onto (supplied) microSD card. ZIP (includes .hex firmware and .exe GUI)
- Tilt Sensor: shows tilt measurement on E-Ink display. HEX
- Ultralow Power Motion switch: turns display icons on or off based on presence or absence of motion. HEX
- Pedometer & fall detector coming soon
Reconfiguring the Board
The EVAL-ADXL362Z-DB firmware can be rewritten using the Renesas Flash Programmer (click here for download links). Instructions for rewriting the firmware are as follows:
- Set jumpers: J6, J7, J8, and J9 (between the USB connector and the switch on the DB board) to the 1-2 position. Set jumper J2 to the 2-3 position for USB power.
We know the jumpers are a pain and we apologize in advance.
Jumper Position J2 1 2 3 J6 1 2 3 J7 1 2 3 J8 1 2 3 J9 1 2 3 - Launch Renesas Flash Programmer V1.03 (download here)
- Create new workspace
- Input RL78/G13 in filter, select R5F100LJ, input workspace name as below.
- Next and select the corresponding COM port for the board.
- Next and browse to the desired .hex file
- Click “Start”
- Configure J6-J9 in position 2-3 for virtual UART
resources/eval/user-guides/inertial-mems/accelerometers/adxl362/eval-adxl362z-db.1350078647.txt.gz · Last modified: 12 Oct 2012 23:50 by Nitzan Gadish