This version (31 Jul 2023 12:16) was approved by Iulia Moldovan.The Previously approved version (05 Feb 2021 15:15) is available.
Table of Contents
AD-FMCDAQ2-EBZ Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the AD-FMCDAQ2-EBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The AD-FMCDAQ2-EBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
The supported OS are:
| Board | HDL | Linux Software | No-OS Software |
|---|---|---|---|
| Arria10 SoC Dev Kit | YES | NO | YES |
| Arria10 GX FPGA Dev Kit | NO (only until hdl_2021_r1 branch) | NO | YES |
| KC705 | YES | YES | YES |
| KCU105 | YES | YES | YES |
| VC707 | NO (only until hdl_2018_r2 branch) | YES | YES |
| ZC706 | YES | YES | YES |
| ZCU102 | YES | YES | YES |
Hardware Setup
In most carriers, the AD-FMCDAQ2-EBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A typical setup is shown below.
resources/eval/user-guides/ad-fmcdaq2-ebz/quickstart.txt · Last modified: 31 Jul 2023 12:16 by Iulia Moldovan